2005 Kia Picanto

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Front Windscreen washer provides insufficient washer liquid Both (3.5 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm 165/60/14 (5.2.3 (e)) DANGEROUS

Power steering inoperative and steering adversely affected (2.1.5 (c) (ii)) DANGEROUS

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge Replacement recommended (5.2.3 (e))

Offside Rear Outer Brake pipe corroded, covered in grease or other material Replacement recommended (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Brake hose has slight corrosion to ferrules all (3.6.B.4e)

Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Front brake disc modified but not seriously weakened (3.5.1n)

coil spring corroded all (2.4.C.1b)

Macpherson strut has slight movement at the upper attachment both front (2.5.A.1c)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

coil spring corroded all (2.4.C.1b)

Anti-lock braking system component excessively damaged nearside front ABS ring (3.4.2)

Anti-lock braking system component excessively damaged offside front ABS ring (3.4.2)

Battery insecure (1.9.1)

Bonnet retaining device ineffective (8.4.2)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Macpherson strut has slight movement at the upper attachment both front (2.5.A.1c)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

coil spring corroded all (2.4.C.1b)

brake disc worn, pitted or scored, but not seriously weakened both front on inner face (3.5.1i)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

brake disc worn, pitted or scored, but not seriously weakened both front on inner face (3.5.1i)

Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

front wiper blades deteriorated

Nearside rear brake binding (3.7.B.1)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

front wiper blades deteriorated

engine light on

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Offside Front Tyre worn close to the legal limit (4.1.E.1)

engine light on

Brake performance not tested (3.7.A.1)

Nearside Front Headlamp aim too low (1.8)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear brake caliper leaking (3.6.A.1)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

nearside front tyre has cut in sidewall,not deep enough to expose cords

nearside rear brake disc corroded

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)