2005 Fiat Punto

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Parking brake lever defective so that it cannot be satisfactorily operated (1.1.6 (d))

Power steering malfunctioning (2.1.5 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pipe corroded, covered in grease or other material across bulkhead (1.1.11 (c))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement BOTH front arm rear bushes just starting to de-bond (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge inner shoulder just starting to wear (5.2.3 (e))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt Boot split (6.1.7 (g) (ii))

Front Suspension arm pin or bush worn but not resulting in excessive movement BOTH front arm rear bushes just starting to de-bond (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge inner shoulder just starting to wear (5.2.3 (e))

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Brake hose has slight corrosion to ferrules & perished (3.6.B.4e)

Nearside Front Inner Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake hose has slight corrosion to ferrules & perished (3.6.B.4e)

Offside Front Inner Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

surface corrosion exhaust

surface corrosion underside of vehicle

Bonnet cannot be secured in the closed position (8.4.1)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Inner Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Upper Shock absorber has an excessively worn bush (2.7.4)

Offside Front Inner Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Upper Shock absorber has an excessively worn bush (2.7.4)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Brake hose has slight corrosion to ferrules & perished (3.6.B.4e)

Nearside Front Inner Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake hose has slight corrosion to ferrules & perished (3.6.B.4e)

Offside Front Inner Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

surface corrosion exhaust

surface corrosion underside of vehicle

Nearside Stop lamp not working (1.2.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)