2006 Fiat Ducato

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner arch (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Near jack mount (5.3.6 (a) (i))

Nearside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner arch (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Near jack mount (5.3.6 (a) (i))

Offside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Direction indicator not working (4.4.1 (a) (ii))

Rear Position lamp not working (4.2.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Nearside Front Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Front body/inner arch to chassis very corroded

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced Whole sill (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced Whole sill (6.1.1 (c) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced Whole sill (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced Whole sill (6.1.1 (c) (i))

Under-body starting to corrode

Brake pad(s) less than 1.5 mm thick both front (3.5.1g)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Nearside rear brake recording little or no effort (3.7.B.5a)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

o/s wiper pivot badly worn.

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

rear brake imbalance may indicate future problems