2008 Kia Rio

Bonnet cannot be secured in the closed position (3.1 (b) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure 205/45R16 (5.2.3 (d) (ii)) DANGEROUS

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge worn on edges (5.2.3 (e))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Suspension arm pin or bush excessively worn front bush (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn front bush (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material to rear (At rear) (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material to rear (At rear) (1.1.11 (c))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Upper Stop lamp(s) non-obligatory stop lamp not working High vision (4.3.1 (a) (ii))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Upper Stop lamp(s) non-obligatory stop lamp not working High vision (4.3.1 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brakes imbalanced across an axle 36% (1.2.1 (b) (i))

Nearside Front Lower Steering locking device missing ball joint (2.1.3 (d))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Lower Steering locking device missing ball joint (2.1.3 (d))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Hydraulic brake calliper leaking and braking performance affected (1.1.16 (b) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Registration plate lamp not working (1.1.C.1d)

Offside rear brake binding (3.7.B.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Registration plate lamp not working (1.1.C.1d)

o/s/f suspension arm bush split from metal housing , no excessive movement at this time

o/s/f suspension arm bush split from metal housing , no excessive movement at this time

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)