2008 Citroen C1

Emissions not tested due to exhaust leak (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Suspension component mounting prescribed area fractured significantly reducing structural strength Rear suspension beam (5.3.6 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Rear beam badly corroded (5.3.6 (a) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Tyre worn close to legal limit/worn on edge Both front (5.2.3 (e))

Front Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Front Coil spring corroded both (5.3.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Child Seat fitted not allowing full inspection of adult belt ()

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Brake hose has slight corrosion to ferrule o/s n/s front/rear (1.1.12 (f) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

rear axle slightly corroded

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Suspension component corroded but not seriously weakened REAR BEAM (5.3.3 (b) (i))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Headlamp aim projected beam image is obviously incorrect Both (4.1.2 (c))

Horn not working (7.7 (a) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Offside Stop lamp(s) remains on when the brakes are released (4.3.2 (a) (iii)) DANGEROUS

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Suspension component corroded but not seriously weakened REAR BEAM (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

rear beam axle corroded

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.C.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

front discs worn

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)