1988 Talbot Motorhome

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength above wheel (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Power steering pipe/hose leaking (2.1.5 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Windscreen wiper blade defective (3.4 (b) (i))

nearside front inner wing is corroding

nearside front out rigger is corroding

nearside front wheel arch is corroding

nearside inner wing is corroding behind wheel

nearside outer sill is corroded on door step

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

nearside door step is corroding

nearside inner wing behind wheel is corroding

nearside inner wing next to gearbox mounting is corroding

offside drive shaft center bearing has slight play

Offside Front Body panel corroded and likely to cause injury door (6.2.1 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

nearside door step is corroding

nearside inner wing behind wheel is corroding

nearside inner wing next to gearbox mounting is corroding

offside drive shaft center bearing has slight play

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Coolant leak ()

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Rear Service brake fluctuating, but not excessively nearside and offside (1.2.1 (e))

offside inner sill is corroding front and rear

slight corrosion above and behind nearside front wheel

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Battery insecure and likely to fall from carrier leisure battery (4.13 (a) (ii))

Nearside Rear Position lamp adversely affected by the operation of another lamp interaction with indicator (4.2.3 (c))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust system insecure (6.1.2 (a))

Headlamp light intensity severely reduced both (4.1.4 (a))

Nearside Direction indicator not working (4.4.1 (a) (ii))

Offside Front Suspension arm attachment bracket/mounting corroded and seriously weakened (5.3.3 (b) (i))

Offside Front Suspension component mounting prescribed area is inadequately repaired (5.3.6 (a) (i))

Offside Headlamp insecure (4.1.1 (c))

Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp switch insecure (4.5.3 (a))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Suspension arm ball joint dust cover no longer prevents the ingress of dirt both front (5.3.4 (b) (ii))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Headlamp switch does not immediately illuminate all main beam headlamps (4.1.3 (a))

Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Windscreen damaged but not adversely affecting driver's view chip (3.2 (a) (i))

Nearside Headlamp reflector slightly defective (4.1.1 (b) (i))

Offside Headlamp reflector slightly defective (4.1.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Windscreen damaged but not adversely affecting driver's view chip (3.2 (a) (i))

Nearside Headlamp reflector slightly defective (4.1.1 (b) (i))

Offside Headlamp reflector slightly defective (4.1.1 (b) (i))

Power steering malfunctioning tighten steering belt (2.1.5 (a))

both headlights starting to fade

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

both headlights starting to fade

Front vallence corroded

Nearside step area corroded but not excessive

Nearside step area corroded but not excessive

Parking brake only just met requirements

Rear Brake load sensing valve stiff (3.6.E.3)

Underde has various areas of corrosion but not excessive

Exhaust mount has been modified (cable tie)

Front scuttle panel ( wiper mount corroded)

Front wipers only just clear screen

Nearside Front Lower Body has slight corrosion Step (6.1.B.2)

Nearside Rear Lower Bumper mount (corner valance) Corroded

Offside Front Inner Vehicle structure has slight corrosion Step (underneath) (6.1.B.2)

Offside Front Lower Front suspension ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Rear Brake load sensing valve stiff (3.6.E.3)

Rear brakes only just meet efficiency

Various corrosion on vehicle which has masking tape on.

Brakes imbalanced across an axle (3.7.B.5b)

Nearside rear brake binding (3.7.B.1)

Nearside rear brake recording little or no effort (3.7.B.5a)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

exhaust tailpipe corroded

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Exhaust system not adequately supported (7.1.1)

Rear Tyre has ply or cords exposed (4.1.D.1b)

Centre Exhaust system not adequately supported (7.1.1)

Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust system not adequately supported (7.1.1)

rear brakes release unevenly (3.7.B.4)

Headlamp deteriorated but light output not reduced (1.7.5a)

N/s front tyre wearing close to limit and starting to perish

Nearside Headlamp insecure (1.7.3)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Headlamp insecure (1.7.3)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Rear Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Rear Rear position lamp(s) insecure (1.1.A.3a)

Brake load sensing valve linkage seized (3.6.E.3) DANGEROUS

Nearside Side repeater not working (1.4.A.2c) DANGEROUS

Offside Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

body corrosion.....wheelarches, bonnet, drivers door, rear vallance area

both rear corner bumpers loose

both wiper blades torn

corrosion beneath drivers door step area

offside rear wheel bearing has slight play

Nearside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Rear Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside Headlamp damaged but light output not reduced (1.7.5a)

Offside Headlamp damaged but light output not reduced (1.7.5a)

Exhaust mounting missing (7.1.1b)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Inner Front Brake lining(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Seat belt insecurely fixed to the vehicles structure (5.2.1a)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Inner Front Brake lining(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Front position lamp(s) not working (1.1.A.3b)

Headlamp insecure (1.7.3)

Nearside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Registration plate lamp not working (1.1.5c)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)