1988 Talbot Express 1300 P

Nearside Front Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Front Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Extensive welded repairs throughout

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

underside of front steps corroded outside prescribed area

Front Battery insecure and likely to fall from carrier Both Batteries (4.13 (a) (ii))

Front Windscreen washer not working (3.5 (a))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Corrosion At Both Front And Rear Mounts Chalked (5.3.6 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Corrosion At Both Front And Rear Hangers And Arch Box Section All Chalked (5.3.6 (a) (i))

Rear Brake load sensing valve linkage defective and function impaired Seized (1.1.17 (a))

Drivers Door Handle Incomplete

Exhaust noisy (8.1.1 (a))

Hazard warning switch faulty (4.4.2 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive Wheel Arch Step Jack Point (5.3.6 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Jack Point Step Area (5.3.6 (a) (i))

Offside Rear Light Lens Damaged

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Nearside Battery insecure (1.9.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension spring mounting prescribed area is excessively corroded chassis behind axle (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is excessively corroded inner wing (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded inner sill near anchor (2.4.A.3)

Offside Rear position lamp(s) not working (1.1.A.3b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Both rear shock absorber turrets beginning to corrode.

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Part of offside front inner wing corroded outwith prescribed area.

Headlamp aim too high (1.8)

Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Battery insecure (1.9.1)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Both rear shock absorber turrets beginning to corrode.

Exhaust has a minor leak of exhaust gases (7.1.2)

Lower rear part of offside front inner wing corroded outside prescribed area.

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Offside Front Driver's door catch deteriorated but the door can still be readily opened and closed (6.2.B.2)

Oil leak

Play in steering rack inner joint(s)

Front Driver's seat insecure (6.2.A.1)

Front Passenger's seat insecure (6.2.A.1)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Hazard warning lamps inoperative (1.4.B.1b)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front Side repeater not working (1.4.A.2c)

Nearside Indicator tell tale inoperative (1.4.A.2a)

Nearside Rear Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Battery insecure (1.9.1)

Offside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Headlamp insecure (1.7.3)

Offside Front Obligatory mirror insecure (8.1.1)

Registration plate lamp not working (1.1.C.1d)

Exhaust has a major leak of exhaust gases (7.1.2) DANGEROUS

Exhaust system not adequately supported (7.1.1) DANGEROUS

Front Brake pipe inadequately supported (3.6.B.1) DANGEROUS

Offside Front Driver's door catch deteriorated but the door can still be readily opened and closed (6.2.B.2)

Oil leak

Play in steering rack inner joint(s)

o/s/f driveshaft has insecure wiring tangled on it

Driver's seat insecure (6.2.A.1)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Headlamp aim too low (1.8)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Headlamp aim too low (1.8)

Offside Rear Suspension spring mounting prescribed area is inadequately repaired (2.4.A.3)

Registration plate lamp not working (1.1.C.1d)

Battery insecure

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Direction indicators not working (1.4.A.2c)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Horn not working (1.6.2a)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Windscreen wiper not operating over a large enough area to give an adequate view (8.2.1c)

Offside Headlamp aim too low (1.8)

Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Front Brake hose slightly deteriorated (3.6.B.4d)

bonnet hinges weak

front discs in poor condition

rear tyre walls perished

Brake performance not tested (3.7.A.1)

Brake pedal anti-slip provision incomplete (3.3.A.1b)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust system not adequately supported (7.1.1)

Hazard warning switch faulty (1.4.B.1d)

Horn not working (1.6.2a)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front Headlamp aim too high (1.8)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Battery insecure

Spare tyre defective

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Brake load sensing valve linkage stiff (3.6.E.3)

Front Vehicle structure has slight corrosion (6.1.B.2)

this vechicle has had extensive body work done to it and in my opion suffers from advanced corr

Front Body has a projection caused by corrosion (6.1.C.1)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Body insecure and dangerous to other road users (6.1.B.1b)

Nearside Rear Body insecure and dangerous to other road users (6.1.B.1b)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Brake hose twisted (found during steering lock to lock check) (2.2.D.2b)

Offside Front Headlamp aim too low (1.8)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Rear Registration plate lamp not working (1.1.5c)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

all tyres slightly out of shape (remoulds)

both front wheel bearings slight roughness

offside cross member corroded to hole outside area

Front registration plate has a feature which changes the appearance or legibility of the characters (6.3.4c)

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Side repeater not working (1.4.A.2c)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp excessively damaged so that the light output is severely reduced (1.7.5a)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Rear fog lamp not working (1.3.2b)

Parking brake lever has no reserve travel (3.1.6b)

Rear Brake pipe inadequately clipped (3.6.B.1)

Rear registration plate has a feature which changes the appearance or legibility of the characters (6.3.4c)

Registration plate lamp not working (1.1.5c)

all tyres slightly out of shape (remoulds)

both front wheel bearings slight roughness

offside front panel corroded to big holes outside of area

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Leaf spring shackle bracket corroded and seriously weakened (2.4.B.6d)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)