1989 Talbot Express 1300 P

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Exhaust system insecure mounting ring missing, all rings perished (6.1.2 (a))

Horn not working (7.7 (a) (ii))

Nearside Front Suspension component mounting prescribed area is inadequately repaired inner wing (5.3.6 (a) (i))

Nearside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Side repeater not working (4.4.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Horn not working (7.7 (a) (ii))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Vehicle structure is fractured and structural rigidity is significantly reduced Front chassis jacking point corroded (6.1.1 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Wheel bearing has slight play both fronts (5.1.3 (a) (i))

Nearside Front Suspension rod pin or bush worn but not resulting in excessive movement Front tie rod bushes splitting (5.3.4 (a) (i))

Nearside Front Vehicle structure is fractured but structural rigidity is not significantly reduced body panel under washer bottle corroded (6.1.1 (a) (i))

Offside Front Suspension rod pin or bush worn but not resulting in excessive movement Front tie rod bushes splitting (5.3.4 (a) (i))

Offside Front Vehicle structure is fractured but structural rigidity is not significantly reduced panel under battery corroded (6.1.1 (a) (i))

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.C.1b) DANGEROUS

2 exhaust rubbers missing but system is secure

offside inner cv gaiter leaking grease

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Body has a sharp edge caused by damage (6.1.C.1)

Nearside Side repeater not working (1.4.A.2c)

Nearside rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.C.1b) DANGEROUS

2 exhaust rubbers missing but system is secure

offside inner cv gaiter leaking grease

sopme brake drag nearside rear

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Hazard warning switch faulty (1.4.B.1d)

Horn not working (1.6.2a)

Offside Registration plate lamp not working (1.1.C.1d)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Vehicle structure has slight corrosion (6.1.B.2)

Nearside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

front discs pitted

inner cv boot insecure

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Hazard warning switch insecure (1.4.B.1d)

Headlamp switch insecure (1.7.1)

Nearside Headlamp insecure (1.7.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp insecure (1.7.3)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Rear fog lamp not working (1.3.2b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Position lamp switch insecure (1.1.A.1)

Rear fog lamp switch insecure (1.3.1a)

Nearside brake disc slightly pitted (3.5.1h)