1988 Talbot Express 1300 P

Emissions not tested exhaust blowing (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Tyre(s) with different aspect ratios are fitted on the same axle. (5.2.3 (b))

Nearside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength strut top mount (5.3.6 (a) (i))

Offside Front Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Front Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength suspension arm mount (5.3.6 (a) (i))

Offside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength strut top mount (5.3.6 (a) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting central (6.2.2 (d) (i))

Offside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt split (6.1.7 (g) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring front mount (5.3.6 (a) (i))

Nearside Headlamp reflector slightly defective (4.1.1 (b) (i))

Nearside Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security central (6.2.2 (d) (i))

Offside Headlamp reflector slightly defective (4.1.1 (b) (i))

Both front struts deteriorating

Both headlight reflectors badly deteriorated

Leaf spring anchor bracket corroded but not seriously weakened Both rear front mounting brackets deteriorating (5.3.1 (b) (i))

Nearside Front inner wheel arch deteriorating at gearbox mounting

Temporary fuel cap fitted

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Exhaust has a major leak of exhaust gases Leak at manifold area (6.1.2 (a))

Nearside Front Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Both front struts deteriorating

Both headlight reflectors badly deteriorated

Leaf spring anchor bracket corroded but not seriously weakened Both rear front mounting brackets deteriorating (5.3.1 (b) (i))

Nearside Front inner wheel arch deteriorating at gearbox mounting

Temporary fuel cap fitted

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Battery insecure aux (1.9.1)

Brake load sensing valve seized (3.6.E.3)

Offside Inner Rear position lamp(s) not working (1.1.A.3b)

Front Brake hose slightly deteriorated both sides, upper hoses (3.6.B.4d)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Rear Brake load sensing valve stiff (3.6.E.3)

Rear Leaf spring has a slightly deteriorated shackle pin rubber bush not resulting in excessive movement both sides (2.4.B.2)

Rear Rear position lamp(s) slightly affected by the operation of another lamp both sides (1.1.A.3f)

both rear tyres has a surface cracks

surface corrosion on front to rear brake pipe

underside surface corrosion

wipers starting to split

Nearside Front Windscreen wiper blade deteriorated (8.2.2)

Oil leak

Oil leak

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

hand brake bit sicky