1989 Talbot Express

Exhaust mounting defective several - but system still secure (6.1.2 (a))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Electrical wiring insulation so damaged or deteriorated it is likely to cause a short-circuit 2 main wires chaffed through on Nearside inner driveshaft joint (4.11 (c) (ii))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt clip missing (6.1.7 (g) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Exhaust mounting defective several - but system still secure (6.1.2 (a))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Exhaust mounting defective x2 missing (6.1.2 (a))

Nearside Obligatory mirror slightly damaged (3.3 (b) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Exhaust mounting defective ALL (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Obligatory mirror slightly damaged (3.3 (b) (i))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis by leaf spring mount (5.3.6 (a) (i))

Exhaust mounting defective ALL (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Obligatory mirror slightly damaged (3.3 (b) (i))

Exhaust mounting defective (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Non obligatory mirror damaged

Exhaust system insecure two mounts missing (6.1.2 (a))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Lower Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Seat belt retracting mechanism defective (7.1.2 (e))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pipe corroded, covered in grease or other material rear of step (1.1.11 (c))

2 exhaust rubber mounts missing

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement track arm bushes both sides (5.3.4 (a) (i))

Nearside Front Seat belt slow to retract

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Lower Vehicle structure is corroded but structural rigidity is not significantly reduced corrosion hole front panel in engine bay (6.1.1 (c) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced corrosion hole front of wheel arch tub (6.1.1 (c) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust silencer slightly loose (8.1.1 (b) (i))

Nearside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt split (2.1.3 (g) (ii))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt split (5.3.4 (b) (ii))

Nearside Rear Brake pipe leaking on a hydraulic braking system pipe corroded and burst while carrying out brake test (1.1.11 (b) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

2 exhaust rubber mounts missing

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement track arm bushes both sides (5.3.4 (a) (i))

Nearside Front Seat belt slow to retract

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Lower Vehicle structure is corroded but structural rigidity is not significantly reduced corrosion hole front panel in engine bay (6.1.1 (c) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced corrosion hole front of wheel arch tub (6.1.1 (c) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust silencer slightly loose (8.1.1 (b) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Suspension rod attachment bracket/mounting insecure (5.3.3 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Service brake lagging in operation (1.2.1 (d))

Nearside Front Suspension rod attachment bracket/mounting likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Driver's view Items removed from driver's view prior to test damaged (3.1 (a) (ii))

Offside Front brake hose slight perishing

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside rear brake binding (3.7.B.1)

Rear fog lamp not working (1.3.2b)

rear brake application uneven (3.7.B.2)

rear brakes release unevenly (3.7.B.4)

Centre Rear Brake pipe slightly corroded from lsv (3.6.B.2c)

Nearside Front Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Brake load sensing valve stiff (3.6.E.3)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Parking brake: efficiency below requirements (3.7.B.7)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Headlamp excessively damaged so that the light output is severely reduced (1.7.5a)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Brake load sensing valve linkage stiff (3.6.E.3)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Headlamp damaged but light output not reduced (1.7.5a)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Battery insecure

Offside Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Battery insecure

Offside Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Brake load sensing valve linkage seized (3.6.E.3)

Front Exhaust mounting missing (7.1.1b)

Nearside Headlamp excessively damaged so that the light output is severely reduced (1.7.5a)

Rear Exhaust mounting missing (7.1.1b)