1990 Talbot Camper

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust mounting defective All exhaust rubber perishing (6.1.2 (a))

Front Integral body structure is corroded but structural rigidity is not significantly reduced Nearside & offside inside top of front wheel arches (6.1.1 (c) (i))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced Jacking point (6.1.1 (c) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Brake pipe corroded, covered in grease or other material In wheel arch (1.1.11 (c))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Front of inner wheel (5.3.6 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material rusty, as pipe passes through inner wing, to hoses (1.1.11 (c))

Offside Front Lower Integral body structure is corroded but structural rigidity is not significantly reduced inner wheel arch, in front of road wheel (6.1.1 (c) (i))

Front Lower Brake pipe slightly corroded offside & nearside pipes that run to hoses in wheel arches (3.6.B.2c)

Front offside & nearside brakes binding slightly

Nearside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Nail in tyre ()

Nearside Rear brake is binding slightly

Offside Front Lower Suspension component mounting prescribed area is corroded but not considered excessive chassis inner wing by tie bar mounting behind bumper & arch to inner wing in front of strut tower (2.4.A.3)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. offside & nearside (3.7.B.6b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Lower Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Inner Front Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Outer Front Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both front pipes are binding slightly

Outer Front Body has a projection caused by corrosion (6.1.C.1)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Lower Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Inner Front Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Outer Front Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both front pipes are binding slightly

Offside Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Rear fog lamp not working (1.3.2b)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp aim too high (1.8)

Offside Upper Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Rear Brake pipe slightly corroded (3.6.B.2c)