1991 Talbot Express 1300 P

Nearside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive Wheel arch (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Wheel arch (5.3.6 (a) (i))

Oil leak, but not excessive Engine (8.4.1 (a) (i))

Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive Wheel arch (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Wheel arch (5.3.6 (a) (i))

Oil leak, but not excessive Engine (8.4.1 (a) (i))

Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt Insecure (6.1.7 (g) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Emissions unable to be completed HC hang up check unable to be performed due to excessive exhaust gasses being emitted from exhaust. (8.2.1.2 (d))

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Exhaust emits excessive dense blue smoke during acceleration (8.2.1.2 (g))

Front Windscreen washer not working (3.5 (a))

Nearside Front Headlamp aim unable to be tested (4.1.2 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Side repeater not working (4.4.1 (a) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security inner sill (6.2.2 (d) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security inner sill (6.2.2 (d) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Exhaust has a major leak of exhaust gases front pipe at join (6.1.2 (a))

Offside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security inner sill (6.2.2 (d) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security inner sill (6.2.2 (d) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Rear fog lamp not working (1.3.2b)

Rear rear brake application uneven (3.7.B.2)

Service brake: efficiency below requirements (3.7.B.7)

Central Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Rear position lamp(s) slightly affected by the operation of another lamp with indicator (1.1.A.3f)

Oil leak ()

exhaust system deteriorating

Offside Front Brake hose slightly deteriorated both (3.6.B.4d)

corrosion to both front door step inner panels

exhaust deteriorating

Nearside Front Outer Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt lower (2.4.G.2)

Nearside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Brake hose slightly deteriorated both (3.6.B.4d)

corrosion to both front door step inner panels

exhaust deteriorating

nearside front inner arch corrode

offside front inner arch corroded

Nearside Inner Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Inner Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside front brake binding (3.7.B.1)

n/s/f brake binding slightly

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Service brake juddering severely (3.7.C.2)

Front brake disc excessively pitted (3.5.1h)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

front brake discs in poor condition

wiper blades perished