2009 Moto Guzzi Nevada Classic

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Headlamp aim projected beam image obviously incorrect Beam "kick up" to the offside and lens twisted. (4.1.2 (c))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Spacers missing from rear rack mounting bolts. Do not use top box.

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Spacers missing from rear rack mounting bolts. Do not use top box.

Rear Stop lamp does not illuminate by the operation of both brake controls Temporary repair. Stop switch connecter under seat defective. Clean or replace. (4.3.2 (a) (iii))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Shock absorber has a reduced damping effect Aftermarket replacement rear shocks are under damped and under sprung. (5.3.2 (b))

Headlamp aim projected beam image obviously incorrect Aftermarket LED headlamp has no beam cut off. (4.1.2 (c))

Rear Brake pedal has insufficient reserve travel Rear brake disc is excessively bent and pushing brake pads back when rear wheel is rotated. (1.1.2 (a))

Registration plate does not conform to the specified requirements Small nunber plates not acceptable after September 2001. (0.1 (d))

Front Forks slightly twised.

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Shock absorber has a reduced damping effect Aftermarket replacement rear shocks are under damped and under sprung. (5.3.2 (b))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

horn noise rough

Front Brake pad(s) close to minimum limit (3.2A1f(ii))

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Rear number plate light not working

Rear Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Front Brake pad(s) close to minimum limit (3.2A1f(ii))

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Rear number plate light not working

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Rear Tyre worn close to the legal limit (4.1.3(ii))