1994 Yamaha TZR125

Front Brake fluid reservoir fluid level below minimum level (1.1.10 (d) (i))

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

Front Suspension component modified so the suspension is inoperative (5.3.3 (c) (ii)) DANGEROUS

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Brake pedal has inadequate reserve travel (3.1.3b)

Brake pedal pivots excessively worn (3.1.3a)

Headlamp aim too high (1.6)

Indicator tell tale not functioning (1.5.2)

Locking device(s) not correctly fitted which may make the motor bicycle dangerous to ride split pin missing on rear axle castle nut (6.2.1h)

Nearside Front Direction indicator incorrect colour (1.5.1b)

Offside Rear Direction indicator insecure (1.5.3b)

Rear Tyre valve stem damaged which could cause sudden tyre deflation (4.1.2c)

Front tyre has been plugged

no movement but noise from head stock

Direction indicators affected by the operation of another lamp indicators not flashing (1.5.1c)

Nearside Front Direction indicators not working (1.5.1c)

Front tyre has been plugged

no movement but noise from head stock

Indicator tell tale not functioning (1.5.2)

Rear position lamp adversely affected by the operation of another lamp (1.1.3b)

Rear reflector on motorcycle missing (1.4.1)

Offside Front Footrest insecure (6.2.1a)

Offside Rear Footrest missing (6.2.1a)

Nearside Rear Footrest missing (6.2.1a)

Offside Front Direction indicator obscured (1.5.1a)

Nearside Front Direction indicator obscured (1.5.1a)

Rear reflector on motorcycle missing (1.4.1)

Registration plate margin less than the minimum requirement (6.3.4g)

Steering headbearing has excessive free play (2.2.2)

Rear Tyre worn close to the legal limit (4.1.3(ii))

rear light bulb not working.

Direction indicators not working (1.5.1c)

Rear Footrest missing (6.2.1a)

Steering movement excessively 'notchy' with the wheel raised (2.2.1b)

Front Headlamp damaged and function impaired (1.2.3a)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))