1999 Triumph Sprint

Clutch lever lock nut loose

Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Rear Brake hose has slight corrosion to ferrules (1.1.12 (f) (i))

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement Front link (5.3.4 (a) (i))

Clutch lever lock nut loose

Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Headlamp aim too low (4.1.2 (a))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Steering operation restricted in free movement from lock to lock Wiring harness (2.1.4 (c))

Rear Brake hose has slight corrosion to ferrules (1.1.12 (f) (i))

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement Front link (5.3.4 (a) (i))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

restricted full lock to right by wiring

Rear Position lamp not working (4.2.1 (a))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Rear Stop lamp not working pressure switch (4.3.1 (a) (ii))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Rear Brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Nail in rear tyre

Front Roller brake test indicates a slightly juddering brake (3.3.A1b)

Exhaust noisy (7.1.2)

Drive chain worn to excess (6.2.1e)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Exhaust noisy (7.1.2)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Tyre worn close to the legal limit (4.1.3(ii))

Horn not working (1.7.3a)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Tyre worn close to the legal limit (4.1.3(ii))

Rear Rear wheel bearings have slight free play (2.4.A.2c)

Centre Exhaust mounting does not fully support the exhaust system (7.1.1.c)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))