1999 Triumph Sprint

Drive chain slightly loose (6.1.7 (c) (i))

Front Tyre worn close to the legal limit (5.2.3 (e))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Central Front Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Drive chain slightly tight (6.1.7 (k) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Tyre worn close to the legal limit (5.2.3 (e))

Rear Brake binding but not excessively (1.2.1 (f))

Rear Drive chain sprocket worn, but not excessively (6.1.7 (c) (i))

fuel staining on near side frame rail

main stand pivot worn

passing light switch inoperative

screen cracked

Offside Front Brake caliper leaking (1.1.16 (b) (i))

Rear Stop lamp switch with a delay in operation (4.3.2 (a) (ii))

Drive chain slightly tight (6.1.7 (k) (i))

Drive chain sprocket worn, but not excessively (6.1.7 (c) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Tyre worn close to the legal limit (5.2.3 (e))

Rear Brake binding but not excessively (1.2.1 (f))

Registration plate slightly loose (0.1 (a))

engine oil level low

evidence of fuel staining on left hand frame rail

front brake lever pivot worn

headlamp flash/passing light switch inoperative

main stand pivot worn

screen cracked

Nearside Front Headlamp light intensity severely reduced Not producing a beam on tester, very dim (4.1.4 (a))

Nearside Rear Direction indicator not working (4.4.1 (a) (ii))

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

Rear Brake pad(s) close to minimum limit (3.2A1f(ii))

Front Front shock absorber has light misting of stanchion (2.3.3)

Brake lever has inadequate reserve travel (3.1.3b)

Front position lamp does not illuminate immediately when switched on High beam (1.1.3a)

Front position lamp flickers when tapped lightly by hand (1.1.3c)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Hydraulic brake control feels spongy (3.1.4a)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front shock absorber seal failed and leaking oil (2.3.3)

Front wheel bearings are excessively rough (2.3.5b)

Front Brake disc(s) slightly pitted (3.2.A1l)