2013 Citroen C1

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both arms rear bushes (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge both wearing on inner edges (5.2.3 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material to flexi (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Brake pipe corroded, covered in grease or other material main runs (1.1.11 (c))

inner sills slight corrosion

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Hazard warning switch faulty (4.4.2 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Headlamp aim too low and too far to the right. (4.1.2 (a))

Offside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

wiper does not park

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Windscreen wiper not operating over a large enough area to give an adequate view wiper arm not parking correctly (8.2.1c)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)